LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2018 >> RAV4 XLE, FWD >> Repair and Diagnosis >> Restraints >> Seat Belts >> Seat Belt (Service Information) (Except Hybrid) >> Front Seat Inner Belt Assembly >> Inspection [12/2012 - 08/2016] >> Procedure

Inspection [12/2012 - 08/2016]: Procedure

  1. INSPECT FRONT SEAT INNER BELT ASSEMBLY LH 
    1. Measure the resistance according to the value(s) in the table below.
      GTY361411Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Connector A
      *2 Connector B
      *a Component without harness connected
      (Front Seat Inner Belt Assembly LH)

      Standard Resistance

      Tester Connection Condition Specified Condition
      A-3 (LSP-) - B-1 Always Below 1 Ω
      A-4 (LSP+) - B-2 Always Below 1 Ω

      If the result is not as specified, replace the front seat inner belt assembly LH.

  2. INSPECT FRONT SEAT INNER BELT ASSEMBLY RH (for Type A) 
    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      3 - 4 Limit switch pushed Below 1 Ω
      3 - 4 Limit switch not pushed 10 kΩ or higher
      GTY368967Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Limit Switch
      *a Component without harness connected
      (Front Seat Inner Belt Assembly RH)

      If the result is not as specified, replace the front seat inner belt assembly RH.

scientia non olet · About LEMON Manuals