DTC P0630: VIN not Programmed or Mismatch - ECM / PCM [12/2012 - 10/2015]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
5. Read the DTCs.

   Powertrain > Engine and ECT > Trouble Codes 

   Result

   Result	Proceed to
   DTC P0630 is output	A
   DTC P0630 and other DTCs are output	B

   If any DTCs other than P0630 are output, troubleshoot those DTCs first.

   NOTE:

   If P0630 is stored, the VIN must be input to the ECM using the Techstream. However, all DTCs are cleared automatically by the Techstream when the VIN is input. If DTCs other than P0630 are output, troubleshoot them first.

Result: 

B 

GO TO DTC CHART:  DIAGNOSTIC TROUBLE CODE CHART [12/2012 - 11/2013]  ,  DIAGNOSTIC TROUBLE CODE CHART [11/2013 - 08/2014]  ,  DIAGNOSTIC TROUBLE CODE CHART [08/2014 - 10/2015] 

Result: 

A 

See step  2

1. Input the VIN.

   Refer to REGISTRATION [12/2012 - ]

Result: 

NEXT 

END