DTC P0617: Starter Relay Circuit High [12/2012 - 10/2015]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Enter the following menus: Powertrain / Engine and ECT / Data List / Primary / Starter Signal.

   Powertrain > Engine and ECT > Data List 

   Tester Display
   Starter Signal

5. Check the value displayed on the Techstream when the vehicle is driven at 20 km/h (12.4 mph) or more.
   WARNING:

   When performing the confirmation driving pattern, obey all speed limits and traffic laws.

   Result

   Condition	Starter Signal	Result
   Driving at 20 km/h (12.4 mph) or more	OFF	A
   	ON	B

Result: 

A 

CHECK FOR INTERMITTENT PROBLEMS:  CHECK FOR INTERMITTENT PROBLEMS [12/2012 - ] 

Result: 

B 

See step  2

1. Inspect the park/neutral position switch assembly.
   • for 2WD

     Refer to INSPECTION [12/2012 - ]

   • for AWD

     Refer to INSPECTION [12/2012 - ]

Result: 

NG 

REPLACE PARK/NEUTRAL POSITION SWITCH ASSEMBLY 

• for 2WD

  Refer to REMOVAL [12/2012 - ]

• for AWD

  Refer to REMOVAL [12/2012 - ]

Result: 

OK 

See step  3

1. Repair or replace harness or connector (starter signal circuit).

Result: 

NEXT 

See step  4

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Clear the DTCs.

   Refer to DTC CHECK / CLEAR [12/2012 - ]

   Powertrain > Engine and ECT > Clear DTCs 

5. Turn the ignition switch off and wait for at least 30 seconds.
6. Drive the vehicle in accordance with the driving pattern described in Confirmation Driving Pattern.
7. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
8. Read the DTCs.

   Powertrain > Engine and ECT > Trouble Codes 

   Result

   Result	Proceed to
   DTC P0617 is output	A
   DTC is not output	B

Result: 

A 

REPLACE ECM:  REMOVAL [12/2012 - ] 

Result: 

B 

END