LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2018 >> RAV4 XLE, FWD >> Repair and Diagnosis >> Engine Performance >> Testing & Diagnosis >> SFI System [2AR-FE] (Diagnostic Codes) (Except Hybrid) (6 Of 7) >> SFI System >> DTC P043E, P043F, P2401, P2402, P2419; Evaporative Emission System Leak Detection Reference Orifice Low Flow [12/2012 - ] >> Typical Enabling Conditions

Typical Enabling Conditions

Monitor runs whenever the following DTCs are not stored None
Atmospheric pressure 70 kPa(abs) [525 mmHg(abs)] or higher, and less than 110 kPa(abs) [825 mmHg(abs)]
Battery voltage 10.5 V or higher
Vehicle speed Less than 4 km/h (2.5 mph)
Ignition switch Off
Time after key-off 5, 7 or 9.5 hours
Canister pressure sensor malfunction (P0452, P0453) Not detected
Purge VSV Not operated by scan tool
Vent valve Not operated by scan tool
Leak detection pump Not operated by scan tool
Both of following conditions met before key-off Conditions 1 and 2
1. Duration that vehicle is driven 5 minutes or more
2. EVAP purge operation Performed
Engine coolant temperature 4.4°C (40°F) or higher, and less than 35°C (95°F)
Intake air temperature 4.4°C (40°F) or higher, and less than 35°C (95°F)