DTC P2610: ECM / PCM Internal Engine Off Timer Performance [08/2014 - ]: Procedure

1. Replace the ECM.

   Refer to REMOVAL [12/2012 - ]

Result: 

NEXT 

See step  2

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Clear the DTCs.

   Powertrain > Engine and ECT > Clear DTCs 

5. Turn the ignition switch off and wait for at least 30 seconds.
6. Turn the ignition switch to ON.
7. Turn the Techstream on.
8. Start the engine and wait for 10 minutes or more.
9. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes / Pending.
10. If no pending DTC is output, the repair has been successfully completed.

    Powertrain > Engine and ECT > Trouble Codes 

Result: 

NEXT 

END