DTC P0037, P0038, P0141, P102D; Oxygen Sensor Heater Control Circuit Low (Bank 1 Sensor 2) [08/2014 - 08/2016]: Description
Refer to DTC P0136.
Refer to DESCRIPTION Refer to DESCRIPTION
HINT:
- Sensor 2 refers to the sensor mounted behind the three-way catalytic converter and located far from the engine assembly.
- When any of these DTCs is stored, the ECM enters fail-safe mode. The ECM turns off the heated oxygen sensor heater in fail-safe mode. Fail-safe mode continues until the ignition switch is turned off.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory | Note |
|---|---|---|---|---|---|---|
| P0037 | Oxygen Sensor Heater Control Circuit Low (Bank 1 Sensor 2) | Heated oxygen sensor heater current is the specified value or less while the heater is operating (1 trip detection logic). |
|
Comes on | DTC stored | DTC for Mexico Models - Applies |
| P0038 | Oxygen Sensor Heater Control Circuit High (Bank 1 Sensor 2) | Heated oxygen sensor heater current reaches high limit (1 trip detection logic). |
|
Comes on | DTC stored | DTC for Mexico Models - Applies |
| P0141 | Oxygen Sensor Heater Circuit Malfunction (Bank 1 Sensor 2) | The cumulative heater resistance correction value exceeds the threshold (2 trip detection logic). |
|
Comes on | DTC stored | DTC for Mexico Models - Applies |
| P102D | O2 Sensor Heater Circuit Performance Bank 1 Sensor 2 Stuck ON | Heated oxygen sensor heater current is higher than the specified value while the heater is not operating (1 trip detection logic). | ECM | Comes on | DTC stored | DTC for Mexico Models - Applies |