LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2018 >> RAV4 XLE, AWD >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical (2AR-FE) (Service Information) (1 Of 2) (Except Hybrid) >> Rear Crankshaft Oil Seal >> Removal [12/2012 - ] >> Procedure

Removal [12/2012 - ]: Procedure

  1. REMOVE ENGINE AND TRANSAXLE 

    Refer to REMOVAL [12/2012 - ] 

  2. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY 
  3. FIX ENGINE ASSEMBLY 

    See step  67

  4. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY 
    1. Using SST, hold the crankshaft pulley.
      GTY365765Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      • SST: 09213-54015 
      • SST: 09330-00021 

      HINT: 

      Part number of installation bolt for SST (crankshaft pulley holding tool): 91551-80650 (quantity: 2)

    2. Remove the 8 bolts, front drive plate spacer, drive plate and ring gear sub-assembly and rear drive plate spacer.
      GTY313837Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. REMOVE REAR ENGINE OIL SEAL 
    1. Using a knife, cut off the lip of the oil seal.
      GTY362192Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Cut Position
      *2 Protective Tape
    2. Using a screwdriver, pry out the oil seal.
      NOTE:

      Do not damage the surface of the oil seal press fit hole or the crankshaft.

      HINT: 

      Tape the screwdriver tip before use.

scientia non olet · About LEMON Manuals