LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2018 >> RAV4 SE, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Automatic Transmission (U760E) - Diagnostics - Introduction) >> Automatic Transaxle System >> How To Proceed With Troubleshooting [12/2012 - ] >> Procedure

How To Proceed With Troubleshooting [12/2012 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. VEHICLE BROUGHT TO WORKSHOP 

    Result: 

    NEXT 

    See step  2

  2. CUSTOMER PROBLEM ANALYSIS 
    1. Refer to How to Troubleshoot ECU Controlled Systems in the Introduction section.

      Refer to: HOW TO PROCEED WITH TROUBLESHOOTING [12/2012 - 11/2013] , HOW TO PROCEED WITH TROUBLESHOOTING [11/2013 - 10/2015] , HOW TO PROCEED WITH TROUBLESHOOTING [10/2015 - 08/2016] , HOW TO PROCEED WITH TROUBLESHOOTING [08/2016 - 08/2017] , HOW TO PROCEED WITH TROUBLESHOOTING [08/2017 - ]

    Result: 

    NEXT 

    See step  3

  3. INSPECT BATTERY VOLTAGE 

    Standard voltage

    11 to 14 V

    If the voltage is below 11 V, recharge or replace the battery before proceeding.

    Result: 

    NEXT 

    See step  4

  4. CONNECT TECHSTREAM TO DLC3* 

    Result: 

    NEXT 

    See step  5

  5. CHECK AND CLEAR DTCS AND FREEZE FRAME DATA* 
    1. Refer to DTC Check/Clear.

      Refer to DTC CHECK / CLEAR [12/2012 - ] 

    Result: 

    NEXT 

    See step  6

  6. VISUAL INSPECTION 

    Result: 

    NEXT 

    See step  7

  7. SELECT CHECK MODE AND PERFORM DIAGNOSIS* 
    1. Refer to Check Mode Procedure.

      Refer to CHECK MODE PROCEDURE [12/2012 - ] 

    Result: 

    NEXT 

    See step  8

  8. PROBLEM SYMPTOM CONFIRMATION 
    1. Refer to Road Test.

      Refer to ROAD TEST [12/2012 - ] 

      Result

      Result Proceed to
      Symptom does not occur A
      Symptom occurs B

    Result: 

    B 

    See step  10

    Result: 

    A 

    See step  9

  9. SYMPTOM SIMULATION 
    1. Refer to Electronic Circuit Inspection Procedure.

      Refer to ELECTRONIC CIRCUIT INSPECTION PROCEDURE [12/2012 - ]

    Result: 

    NEXT 

    See step  10

  10. DTC CHECK* 
    1. Refer to DTC Check/Clear.

      Refer to DTC CHECK / CLEAR [12/2012 - ] 

      Result

      Result Proceed to
      DTC is not output A
      DTC is output B

    Result: 

    B 

    See step  18

    Result: 

    A 

    See step  11

  11. BASIC INSPECTION 
    1. Refer to Park/Neutral Position Switch.

      Refer to ON-VEHICLE INSPECTION [12/2012 - ]

    2. Refer to Shift Lever Assembly.

      Refer to ON-VEHICLE INSPECTION [12/2012 - ]

    Result: 

    NG 

    See step  21

    Result: 

    OK 

    See step  12

  12. MECHANICAL SYSTEM TESTS* 
    1. Refer to Mechanical System Tests.

      Refer to MECHANICAL SYSTEM TESTS [12/2012 - ] 

    Result: 

    NG 

    See step  17

    Result: 

    OK 

    See step  13

  13. HYDRAULIC TEST* 
    1. Refer to Hydraulic Test.

      Refer to HYDRAULIC TEST [12/2012 - ] 

    Result: 

    NG 

    See step  17

    Result: 

    OK 

    See step  14

  14. MANUAL SHIFTING TEST 
    1. Refer to Manual Shifting Test.

      Refer to MANUAL SHIFTING TEST [12/2012 - ] 

    Result: 

    NG 

    See step  16

    Result: 

    OK 

    See step  15

  15. PROBLEM SYMPTOMS TABLE CHAPTER 1 
    1. Refer to Problem Symptoms Table.

      Refer to PROBLEM SYMPTOMS TABLE [12/2012 - 10/2015] Refer to PROBLEM SYMPTOMS TABLE [10/2015 - ] 

    Result: 

    NG 

    See step  19

    Result: 

    OK 

    See step  16

  16. PROBLEM SYMPTOMS TABLE CHAPTER 2 
    1. Refer to Problem Symptoms Table.

      Refer to PROBLEM SYMPTOMS TABLE [12/2012 - 10/2015] Refer to PROBLEM SYMPTOMS TABLE [10/2015 - ] 

    Result: 

    NEXT 

    See step  17

  17. COMPONENT INSPECTION 

    Result: 

    NG 

    See step  21

    Result: 

    OK 

    See step  18

  18. DTC CHART 
    1. Refer to Diagnostic Trouble Code Chart.

      Refer to DIAGNOSTIC TROUBLE CODE CHART [12/2012 - 11/2013] Refer to DIAGNOSTIC TROUBLE CODE CHART [11/2013 - 08/2014] Refer to DIAGNOSTIC TROUBLE CODE CHART [08/2014 - 10/2015] Refer to DIAGNOSTIC TROUBLE CODE CHART [10/2015 - 08/2016] Refer to DIAGNOSTIC TROUBLE CODE CHART [08/2016 - 08/2017] Refer to DIAGNOSTIC TROUBLE CODE CHART [08/2017 - ] 

    Result: 

    NEXT 

    See step  19

  19. CIRCUIT INSPECTION 

    Result: 

    NEXT 

    See step  20

  20. IDENTIFICATION OF PROBLEM 

    Result: 

    NEXT 

    See step  21

  21. REPAIR OR REPLACE 

    Result: 

    NEXT 

    See step  22

  22. CONFIRMATION TEST 

    Result: 

    NEXT 

    END 

scientia non olet · About LEMON Manuals