LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2018 >> RAV4 SE, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission (U760E) - Service Information (1 Of 2)) >> Transmission Wire >> Removal [12/2012 - ] >> Procedure

Removal [12/2012 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE TRANSMISSION VALVE BODY ASSEMBLY 

    Refer to REMOVAL [12/2012 - ] 

  2. REMOVE TRANSMISSION WIRE 
    1. Disconnect the connector of the transmission revolution sensor.
      GTY304937Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disconnect the 7 connectors of the shift solenoid valve.
    3. Disengage the clamp and disconnect the transmission wire.
    4. Remove the bolt and lock plate and disconnect the temperature sensor from the transmission valve body assembly.
    5. Remove the O-rings from the temperature sensor.
    6. Remove the bolt and lock plate and remove the transmission wire from the transmission valve body assembly.
      GTY308029Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals