Replacement [12/2012 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- REMOVE FRONT DRIVE SHAFT ASSEMBLY
Refer to REMOVAL [12/2012 - ]
- REMOVE TRANSAXLE CASE OIL SEAL LH
- REMOVE TRANSAXLE CASE OIL SEAL RH
- INSTALL TRANSAXLE CASE OIL SEAL RH
- Using SST and a hammer, tap in a new transaxle case oil seal RH.
- SST: 09316-60011
- 09316-00011
Oil seal driven in depth
-0.5 to 0.5 mm (-0.0197 to 0.0197 in.)
NOTE:Check that the transaxle case oil seal RH is installed in the correct direction.
- SST: 09316-60011
- Coat the lip of the transaxle case oil seal RH with MP grease.
- Using SST and a hammer, tap in a new transaxle case oil seal RH.
- INSTALL TRANSAXLE CASE OIL SEAL LH
- Using SST and a hammer, tap in a new transaxle case oil seal LH.
- SST: 09316-10010
- SST: 09950-70010
- 09951-07150
Oil seal driven in depth
-0.5 to 0.5 mm (-0.0197 to 0.0197 in.)
NOTE:Check that the transaxle case oil seal LH is installed in the correct direction.
- Coat the lip of the transaxle case oil seal LH with MP grease.
- Using SST and a hammer, tap in a new transaxle case oil seal LH.
- INSTALL FRONT DRIVE SHAFT ASSEMBLY
Refer to INSTALLATION [12/2012 - 08/2016] or INSTALLATION [08/2016 - ]