Typical Enabling Conditions
WARNING: This page is about a different variant/trim than selected.
ALL
| The monitor will run whenever the following DTCs are not stored | P0712, P0713 (ATF temperature sensor circuit) P0115, P0117, P0118 (ECT sensor circuit) P0715, P0717 (Turbine speed sensor circuit) P0791, P0793 (Intermediate shaft speed sensor circuit) P0748 (Shift solenoid valve SL1 circuit) P0778 (Shift solenoid valve SL2 circuit) P0798 (Shift solenoid valve SL3 circuit) P2810 (Shift solenoid valve SL4 circuit) P0327, P0328 (KCS circuit) P0120, P0121, P0122, P0123, P0220, P0222, P0223, P0604, P0606, P060A, P060B, P060D, P060E, P0657, P1607, P2102, P2103, P2111, P2112, P2118, P2119, P2135 (ETCS) U0100 (CAN communication system) |
| ATF temperature sensor circuit | Not circuit malfunction |
| ECT (Engine coolant temperature) sensor circuit | Not circuit malfunction |
| Turbine speed sensor circuit | Not circuit malfunction |
| Intermediate shaft speed sensor circuit | Not circuit malfunction |
| Shift solenoid valve SL1 circuit | Not circuit malfunction |
| Shift solenoid valve SL2 circuit | Not circuit malfunction |
| Shift solenoid valve SL3 circuit | Not circuit malfunction |
| Shift solenoid valve SL4 circuit | Not circuit malfunction |
| KCS (Knock control sensor) circuit | Not circuit malfunction |
| ETCS (Electronic throttle control system) | Not system down |
| CAN communication system | Not system down |
| Transmission range | "D" |
| Duration time from shifting "N" to "D" | 4 sec. or more |
| ATF temperature | -10°C (14°F) or higher |
| Engine | Starting |
OFF MALFUNCTION (A)
| ECM selected gear | 2nd |
| Throttle valve opening angle | 3% or more |
| ECM indicated pressure value of SL1 | 1200 kPa (12.2 kgf/cm2 , 174 psi) |
| ECM indicated pressure value of SL2 | 0 kPa (0 kgf/cm2 , 0 psi) |
| ECM indicated pressure value of SL3 | 1200 kPa (12.2 kgf/cm2 , 174 psi) |
OFF MALFUNCTION (B)
| ECM selected gear | 6th |
| Throttle valve opening angle | 3% or more |
| ECM indicated pressure value of SL1 | 0 kPa (0 kgf/cm2 , 0 psi) |
| ECM indicated pressure value of SL2 | 1200 kPa (12.2 kgf/cm2 , 174 psi) |
| ECM indicated pressure value of SL3 | 1200 kPa (12.2 kgf/cm2 , 174 psi) |
OFF MALFUNCTION (C)
| ECM selected gear | 2nd |
| Vehicle speed | 2 km/h (1.2 mph) or more |
| Throttle valve opening angle: (When condition "D" is not detected) |
6.5% or more at engine speed of 2000 rpm (Condition varies with engine speed) |
| Throttle valve opening angle: (When condition "D" is detected) |
3.0% or more at output speed of 750 rpm (Condition varies with output speed) |
| ECT | 40°C (104°F) or higher |
OFF MALFUNCTION (D)
| Throttle valve opening angle: (After transition to 2nd gear) |
3.0% or more at output speed of 750 rpm (Condition varies with output speed) |
ON MALFUNCTION
| ECM selected gear | 1st |
| Vehicle speed | 2 to 40 km/h (1.2 to 24.9 mph) |
| Engine speed - Turbine speed | 50 rpm or more |
| ECT | 40°C (104°F) or higher |