LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2018 >> RAV4 Limited, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Automatic Transmission (U760E) - Diagnostic Codes) >> Automatic Transaxle System >> DTC P0791: Intermediate Shaft Speed Sensor "A" Circuit; DTC P0793: Intermediate Shaft Speed Sensor "A" [12/2012 - 10/2015] >> Monitor Description

Monitor Description

WARNING: This page is about a different variant/trim than selected.

The NT terminal of the ECM detects a pulse signal from speed sensor NT (input RPM). The ECM calculates gear shifts by comparing the signal from speed sensor NT with the signal from speed sensor NC.

While the vehicle is operating in 2nd, 3rd, 4th or 5th gear with the shift lever in D, if the input shaft speed is less than 300 rpm*1 although the output shaft speed is more than 1000 rpm*2, the ECM interprets this as a fault, illuminates the MIL and stores the DTC.

HINT: 

scientia non olet · About LEMON Manuals