Monitor Description

WARNING: This page is about a different variant/trim than selected.

The NT terminal of the ECM detects a pulse signal from speed sensor NT (input RPM). The ECM calculates gear shifts by comparing the signal from speed sensor NT with the signal from speed sensor NC.

While the transaxle is operating in 2nd, 3rd, 4th, 5th or 6th gear with the shift lever in D, if the input shaft speed is less than 300 rpm*1 although the output shaft speed is more than 1000 rpm*2, the ECM interprets this as a fault, illuminates the MIL and stores the DTC.

HINT:

*1: A pulse is not output or is irregularly output.
*2: The vehicle speed is 50 km/h (31 mph) or more.