DTC P0715, P0717; Input / Turbine Speed Sensor Circuit Malfunction [12/2012 - 10/2015]: Description
WARNING: This page is about a different variant/trim than selected.
This sensor detects the rotation speed of the turbine which indicates the input speed of the transaxle. By comparing the input turbine speed (speed sensor NT) signal with the counter gear speed (speed sensor NC) signal, the ECM detects the shift timing of the gears and appropriately controls the engine torque and hydraulic pressure according to various conditions. As a result, the gears shift smoothly.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory |
|---|---|---|---|---|---|
| P0715 | Input / Turbine Speed Sensor Circuit Malfunction | The speed sensor input voltage is either higher than 1.9 V or below 0.1 V for 4.5 sec. or more (1-trip detection logic). |
|
Comes on | DTC stored |
| P0717 | Input Speed Sensor Circuit No Signal | All conditions are met for 5 sec. or more (1-trip detection logic): (a) Gear change is not performed. (b) Gear position is 2nd, 3rd, 4th, 5th or 6th. (c) Transmission input shaft speed is less than 300 rpm. (d) Transmission output shaft speed is 1000 rpm or more. (e) Park/neutral position switch NSW and R input signals are OFF. |
|
Comes on | DTC stored |