DTC P0711: Transmission Fluid Temperature Sensor "A" Performance [12/2012 - 11/2013]: Procedure
WARNING: This page is about a different variant/trim than selected.
- CHECK OTHER DTCS OUTPUT (IN ADDITION TO DTC P0711)
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Turn the Techstream on.
- Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Powertrain > Engine and ECT > Trouble Codes
- Read the DTCs using the Techstream.
Result
Result Proceed to Only P0711 is output A P0711 and other DTCs are output B HINT:
If any other codes besides P0711 are output, perform troubleshooting for those DTCs first.
Result:
B
GO TO DTC CHART: DIAGNOSTIC TROUBLE CODE CHART [12/2012 - 11/2013]
Result:
A
See step 2
- CHECK TRANSAXLE FLUID LEVEL
- Check the transaxle fluid level.
Refer to ADJUSTMENT [12/2012 - 10/2015]
OK
Automatic transaxle fluid level is correct.
Result:
OK
REPLACE ATF TEMPERATURE SENSOR (TRANSMISSION WIRE): REMOVAL [12/2012 - ]
Result:
NG
ADJUST FLUID LEVEL: ADJUSTMENT [12/2012 - 10/2015]
- Check the transaxle fluid level.