LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2018 >> RAV4 LE, AWD >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System (Service Information) (Except Hybrid) >> Curtain Shield Airbag Assembly >> Removal [12/2012 - ] >> Procedure

Removal [12/2012 - ]: Procedure

  1. PRECAUTION 
    WARNING:

    Be sure to read Precaution thoroughly before servicing.

    Refer to PRECAUTION [12/2012 - ]

    NOTE:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Refer to PRECAUTION [12/2012 - ]

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    WARNING:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to INITIALIZATION [12/2012 - 10/2015] Refer to INITIALIZATION [10/2015 - 08/2016] Refer to INITIALIZATION [08/2016 - ]

  3. REMOVE ROOF HEADLINING ASSEMBLY 

    Refer to REMOVAL [12/2012 - 10/2015] Refer to REMOVAL [10/2015 - 08/2017] Refer to REMOVAL [08/2017 - ]

  4. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH 
    WARNING:

    When storing the curtain shield airbag assembly LH, keep the airbag deployment side facing upward.

    1. Check that the ignition switch is off.
    2. Check that the cable is disconnected from the negative (-) battery terminal.
      WARNING:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Using a screwdriver with the tip wrapped with protective tape, release the airbag connector lock and disconnect the curtain shield airbag connector.
      NOTE:

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.

      GTY369761Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Protective Tape
      *2 Connector Lock
    4. Remove the 7 clips.

      HINT: 

      • Using needle-nose pliers, release the lock by pinching the 2 locks of the pin, and pull out the pin from the clip.
      • Using 2 screwdrivers, detach the 2 claws by inserting the screwdrivers into the grooves of the clip as shown in the illustration, and then remove the clip from the vehicle body.
    5. Detach the 4 claws.
    6. Remove the 2 bolts and curtain shield airbag assembly LH.
      NOTE:

      The bolts must not be reused.

      GTY366118Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Pin *2 Clip
      *3 Bolt - -
scientia non olet · About LEMON Manuals