Inspection [10/2015 - ]: Procedure
- INSPECT STOP LIGHT SWITCH ASSEMBLY
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Switch Condition Specified Condition A5-1 - A5-2 Shaft not pushed 10 kΩ or higher Shaft pushed Below 1 Ω A5-3 - A5-4 Shaft not pushed Below 1 Ω Shaft pushed 10 kΩ or higher If the result is not as specified, replace the stop light switch assembly.
*a Component without harness connected
(Stop Light Switch Assembly)*b Shaft
- Measure the resistance according to the value(s) in the table below.