LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2018 >> RAV4 LE, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Exterior Lights >> Lighting System (Exterior) - Service Information - (Except Hybrid) >> Rear Combination Light Assembly >> Inspection [10/2015 - ] >> Procedure

Inspection [10/2015 - ]: Procedure

  1. INSPECT REAR COMBINATION LIGHT ASSEMBLY LH (for LED Type Tail and Stop Light) 
    1. Apply battery voltage to the connector and check the light illumination condition.
      GTY593544Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Rear Combination Light assembly LH)

      OK

      Condition Specified Condition
      Battery positive (+) → N13-2 (B)
      Battery negative (-) → N13-4 (E)      		 Taillight and rear side marker light illuminates
      Battery positive (+) → N13-1 (B)
      Battery negative (-) → N13-4 (E)      		 Stop light illuminates

      If the result is not as specified, replace the rear combination light assembly LH.

  2. INSPECT REAR COMBINATION LIGHT ASSEMBLY RH (for LED Type Tail and Stop Light) 
    1. Apply battery voltage to the connector and check the light illumination condition.
      GTY593542Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Rear Combination Light assembly RH)

      OK

      Condition Specified Condition
      Battery positive (+) → M19-2 (B)
      Battery negative (-) → M19-4 (E)      		 Taillight and rear side marker light illuminates
      Battery positive (+) → M19-1 (B)
      Battery negative (-) → M19-4 (E)      		 Stop light illuminates

      If the result is not as specified, replace the rear combination light assembly RH.

scientia non olet · About LEMON Manuals