LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2018 >> Prius Two Eco >> Repair and Diagnosis >> Steering >> Steering Column >> Steering Column - Service Information >> Steering Wheel >> Installation [12/2018 - ] >> Procedure

Installation [12/2018 - ]: Procedure

  1. INSTALL STEERING WHEEL HEATER CONTROL ASSEMBLY (w/ Steering Heater) 

    See step  1

  2. INSTALL LOWER STEERING WHEEL BOSS COVER (w/o Steering Heater) 
    1. GTY574746Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Engage the 6 claws and 4 pins to install the lower steering wheel boss cover to the steering wheel sub-assembly.

  3. INSTALL STEERING PAD SWITCH ASSEMBLY 

    See step  1

  4. INSTALL CRUISE CONTROL SWITCH WIRE 
    1. Install the cruise control switch wire.
  5. INSTALL CRUISE CONTROL MAIN SWITCH 

    Refer to PROCEDURE - Step 1

  6. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD 
  7. INSPECT AND ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 7

  8. INSTALL STEERING WHEEL ASSEMBLY 
    1. Align the matchmarks on the steering wheel assembly and steering main shaft to install the steering wheel assembly.
      GTY550347Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Matchmark
    2. Install the steering wheel assembly set nut.

      Torque: 50 N.m (510 kgf.cm, 37 ft./lbf) 

    3. Connect 2 connectors to the spiral cable with sensor sub-assembly.
      GTY574749Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  9. CHECK STEERING WHEEL CENTER POINT 
  10. INSTALL HORN BUTTON ASSEMBLY 

    Refer to INSTALLATION [11/2015 - ]

scientia non olet · About LEMON Manuals