Freeze Frame Data [07/2020 - ]

FREEZE FRAME DATA
1. Whenever a meter DTC is detected, the combination meter mirror ECU stores the current vehicle state as freeze frame data.

CHECK FREEZE FRAME DATA

Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menus: Body Electrical / Head Up Display / Trouble Codes.
According to the Techstream display, select a DTC that stored freeze frame data.

Read the freeze frame data recorded when the DTC was stored.

HEAD UP DISPLAY

Tester Display	Condition	Displayed Item
B150A	Lost Communication with HMI-LAN	Trip Elapsed time after turning the power switch on (IG)
U0100	Lost Communication with ECM / PCM "A"
U0142	Lost Communication with Body Control Module "B"
U0163	Lost Communication with Navigation Control Module
U023A*	Lost Communication with Front Camera Module

*: w/ Forward Recognition Camera

CLEAR FREEZE FRAME DATA
NOTE:
Clearing the DTCs will also clear the freeze frame data.
1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Clear DTCs and freeze frame data.
  Refer to DTC CHECK / CLEAR [11/2015 - ]
  
  Body Electrical > Head Up Display > Clear DTCs