LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2018 >> Prius Prime Plus >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> (Door / Hatch) (Service Information) (2 Of 2) >> Charge Lid Opener Motor Assembly >> Removal [09/2016 - 05/2019] >> Procedure

Removal [09/2016 - 05/2019]: Procedure

  1. REMOVE TONNEAU COVER ASSEMBLY 

    Refer to PROCEDURE - Step 1

  2. REMOVE REAR NO. 2 FLOOR BOARD 

    Refer to PROCEDURE - Step 2

  3. REMOVE REAR NO. 4 FLOOR BOARD 

    Refer to PROCEDURE - Step 3

  4. REMOVE REAR NO. 3 FLOOR BOARD 

    Refer to PROCEDURE - Step 4

  5. REMOVE REAR NO. 1 FLOOR BOARD 

    Refer to PROCEDURE - Step 5

  6. REMOVE DECK FLOOR BOX LH 

    Refer to PROCEDURE - Step 6

  7. REMOVE DECK FLOOR BOX RH 

    Refer to PROCEDURE - Step 7

  8. REMOVE DECK TRIM SERVICE HOLE COVER 

    Refer to PROCEDURE - Step 2

  9. REMOVE REAR DECK TRIM COVER 

    Refer to PROCEDURE - Step 9

  10. REMOVE REAR SEAT HEADREST ASSEMBLY 

    Refer to PROCEDURE - Step 2

  11. REMOVE REAR SEATBACK HINGE COVER 

    Refer to PROCEDURE - Step 4

  12. REMOVE REAR SEATBACK ASSEMBLY RH 

    Refer to PROCEDURE - Step 5

  13. REMOVE REAR SEAT CUSHION ASSEMBLY RH 

    HINT: 

    Use the same procedure as for the LH side.

    Refer to PROCEDURE - Step 6

  14. REMOVE REAR SEAT CUSHION LOCK HOOK 

    Refer to PROCEDURE - Step 8

  15. REMOVE REAR DOOR SCUFF PLATE RH 

    HINT: 

    Use the same procedure as for the LH side.

    Refer to PROCEDURE - Step 14

  16. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH 
    1. Disconnect the rear door opening trim weatherstrip RH.
  17. REMOVE REAR UNDER SIDE COVER RH 

    HINT: 

    Use the same procedure as for the LH side.

    Refer to PROCEDURE - Step 31

  18. REMOVE REAR SEATBACK HINGE SUB-ASSEMBLY RH 

    HINT: 

    Use the same procedure as for the LH side.

    Refer to PROCEDURE - Step 32

  19. REMOVE REAR SEAT SIDE GARNISH RH 

    HINT: 

    Use the same procedure as for the LH side.

    Refer to PROCEDURE - Step 33

  20. REMOVE ROPE HOOK (w/o Garage Door Opener System) 

    HINT: 

    Use the same procedure as for the LH side.

    Refer to PROCEDURE - Step 34

  21. REMOVE NO. 2 ROPE HOOK (w/o Garage Door Opener System) 

    HINT: 

    Use the same procedure as for the LH side.

    Refer to PROCEDURE - Step 35

  22. REMOVE NO. 1 TONNEAU COVER HOLDER CAP (w/ Garage Door Opener System) 

    HINT: 

    Use the same procedure as for the LH side.

    Refer to PROCEDURE - Step 36

  23. REMOVE TONNEAU COVER HOOK A (w/ Garage Door Opener System) 

    HINT: 

    Use the same procedure as for the LH side.

    Refer to PROCEDURE - Step 37

  24. REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY 

    Refer to PROCEDURE - Step 1

  25. REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH 

    HINT: 

    Use the same procedure as for the LH side.

    Refer to PROCEDURE - Step 38

  26. REMOVE NO. 1 HYBRID BATTERY INTAKE DUCT 

    Refer to PROCEDURE - Step 44

  27. REMOVE NO. 2 HYBRID BATTERY INTAKE DUCT 

    Refer to PROCEDURE - Step 45

  28. DISCONNECT AC CHARGER INLET CABLE (w/o CABLE EV CHARGER LOCK ASSEMBLY) 

    See step  28

  29. DISCONNECT AC CHARGER INLET CABLE WITH CABLE EV CHARGER LOCK ASSEMBLY (w/ CABLE EV CHARGER LOCK ASSEMBLY) 

    See step  29

  30. REMOVE FUEL FILLER OPENING LID LOCK BRACKET 

    See step  30

  31. REMOVE CHARGING PORT OPENING LID LOCK RETAINER 
    1. Turn and remove the charging port opening lid lock retainer as indicated by the arrows, in the order shown in the illustration.
      GTY713907Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Turn in this Direction (1)
      Remove in this Direction (2)
  32. REMOVE CHARGE LID LOCK WITH MOTOR ASSEMBLY 
    1. Disconnect the connector.
      GTY709290Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disengage the 2 claws to remove the charge lid lock with motor assembly.
scientia non olet · About LEMON Manuals