Installation [04/2018 - ]: Procedure
WARNING: This page is about a different car, the 2022 Toyota Avalon, 2021 Toyota Avalon, 2020 Toyota Avalon, and 2019 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY
- Apply adhesive to 2 or 3 threads of the engine oil pressure switch assembly.
Adhesive
Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
*a Adhesive *b Oil Inlet Port NOTE:- Do not apply adhesive to the oil inlet port of the engine oil pressure switch assembly.
- Install the engine oil pressure switch assembly within 3 minutes of applying adhesive.
- Using a 24 mm deep socket wrench, install the engine oil pressure switch assembly.
Torque: 15 N*m (153 kgf*cm, 11 ft.*lbf)
NOTE:Do not start the engine for at least 1 hour after installation.
- Connect the engine oil pressure switch assembly connector.
- Engage the clamp to connect the wire harness protector.
- Apply adhesive to 2 or 3 threads of the engine oil pressure switch assembly.
- ADD ENGINE OIL
Refer to PROCEDURE - Step 8 [04/2018 - 08/2021] , or refer to PROCEDURE - Step 8 [08/2021 - ]
- CHECK ENGINE OIL LEVEL
Refer to PROCEDURE - Step 1
- INSPECT FOR OIL LEAK
Refer to PROCEDURE - Step 9 [04/2018 - 08/2021] , or refer to PROCEDURE - Step 9 [08/2021 - ]
- INSTALL FRONT FENDER APRON SEAL RH
Refer to PROCEDURE - Step 66