Installation [04/2018 - ]: Procedure
WARNING: This page is about a different car, the 2022 Toyota Avalon, 2021 Toyota Avalon, 2020 Toyota Avalon, and 2019 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL SPARK PLUG
Refer to PROCEDURE - Step 1
- INSTALL IGNITION COIL ASSEMBLY
HINT:
Perform "Inspection After Repair" after replacing an ignition coil assembly.
Refer to INITIALIZATION [04/2018 - 08/2019] , or refer to INITIALIZATION [08/2019 - ]
- Install the 3 ignition coil assemblies to the cylinder head cover sub-assembly with the 3 bolts.
Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
NOTE:If an ignition coil assembly has been struck or dropped, replace it.
HINT:
Install the same parts to their original positions.
- Connect the 3 ignition coil assembly connectors.
- Engage the 2 wire harness clamps.
- Engage the 4 clamps to install the vacuum hose to the intake air surge tank assembly.
- Install the 3 ignition coil assemblies to the cylinder head cover sub-assembly LH with the 3 bolts.
Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
NOTE:If an ignition coil assembly has been struck or dropped, replace it.
HINT:
Install the same parts to their original positions.
- Connect the 3 ignition coil assembly connectors.
- Install the 3 ignition coil assemblies to the cylinder head cover sub-assembly with the 3 bolts.
- INSTALL V-BANK COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 46
- PERFORM INITIALIZATION
- Perform "Inspection After Repair" after replacing an ignition coil assembly or spark plug.
Refer to INITIALIZATION [04/2018 - 08/2019] , or refer to INITIALIZATION [08/2019 - ]
- Perform "Inspection After Repair" after replacing an ignition coil assembly or spark plug.