Removal [08/2021 - ]: Procedure
WARNING: This page is about a different car, the 2022 Toyota Avalon, 2021 Toyota Avalon, 2020 Toyota Avalon, and 2019 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
- DRAIN ENGINE COOLANT (for Engine)
Refer to PROCEDURE - Step 1
- REMOVE COOL AIR INTAKE DUCT SEAL
Refer to PROCEDURE - Step 1
- REMOVE INLET AIR CLEANER ASSEMBLY
Refer to PROCEDURE - Step 5
- REMOVE NO. 2 ENGINE COOLANT TEMPERATURE SENSOR
- Disconnect the No. 2 engine coolant temperature sensor connector.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- Remove the clip and No. 2 engine coolant temperature sensor from the radiator pipe.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
NOTE:
If the No. 2 engine coolant temperature sensor has been struck or dropped, replace it.
- REMOVE INVERTER WITH CONVERTER ASSEMBLY
Refer to REMOVAL [08/2021 - ]
- REMOVE ENGINE COOLANT TEMPERATURE SENSOR
- Disconnect the engine coolant temperature sensor connector.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- Remove the clip and engine coolant temperature sensor from the water outlet.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
NOTE:
If the engine coolant temperature sensor has been struck or dropped, replace it.