Removal [11/2015 - ]: Procedure
- PRECAUTION NOTE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (Refer to PRECAUTION [11/2015 - 06/2017] and Refer to PRECAUTION [06/2017 - ] ).
- REMOVE FRONT FLOOR COVER RH
Refer to PROCEDURE - Step 3 and Refer to PROCEDURE - Step 3
- DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [11/2015 - 06/2017] and Refer to INITIALIZATION [06/2017 - ] ).
- REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
Refer to PROCEDURE - Step 4 and Refer to PROCEDURE - Step 4
- REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY
Refer to PROCEDURE - Step 5 and Refer to PROCEDURE - Step 5
- REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH
Refer to PROCEDURE - Step 6 and Refer to PROCEDURE - Step 6
- REMOVE CENTER INSTRUMENT PANEL REGISTER ASSEMBLY
Refer to PROCEDURE - Step 7 and Refer to PROCEDURE - Step 7
- REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
Refer to PROCEDURE - Step 8 and Refer to PROCEDURE - Step 8
- REMOVE COMBINATION METER ASSEMBLY