LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2018 >> Prius C One >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Rear Suspension (Service Information) >> Rear Shock Absorber >> Disposal [11/2015 - ] >> Procedure

Disposal [11/2015 - ]: Procedure

  1. DISPOSE OF REAR SHOCK ABSORBER ASSEMBLY 
    1. Disposal using a drill
      GTY164143Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002.
      1. Fully extend the piston rod and secure the rear shock absorber assembly at an angle in a vise.
      2. Using a drill, slowly make a hole at the position indicated by the arrow in the illustration to discharge the gas inside.
        WARNING:

        Be careful when drilling because shards of metal may fly about, so always use proper safety equipment.

        HINT: 

        The gas is colorless, odorless and non-poisonous.

scientia non olet · About LEMON Manuals