Installation [11/2015 - 06/2017]: Procedure

1. Install the battery insulator.
2. Install the battery.
3. Connect the battery ventilation hose to the battery without kinking it.

   HINT: 

   Push in the battery ventilation hose to the battery until a click sound is heard.

4. Connect the positive (+) battery terminal with the nut.

   Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 

5. Install the battery terminal cap.
6. Install the battery clamp with the 2 nuts.

   Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 

1. Connect the negative battery terminal with the nut.

   Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 

   NOTE:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [11/2015 - 06/2017] ).

Refer to PROCEDURE - Step 7