| Steering Angle Sensor Communication Stop Mode |
Either condition is met:
- "Spiral cable (Steering Angle Sensor)" is not displayed on the "CAN Bus Check" screen of the Techstream (Refer to PROBLEM SYMPTOMS TABLE [11/2015 - ]
)
- Communication system DTCs (DTCs that start with U) that are output correspond to "Steering Angle Sensor Communication Stop Mode" in "DTC Combination Table" (Refer to DIAGNOSIS SYSTEM [11/2015 - ]
)
|
- Spiral cable with sensor sub-assembly (steering sensor) branch line or connector
- Power source circuit of spiral cable with sensor sub-assembly (steering sensor)
- Spiral cable with sensor sub-assembly (steering sensor) ground circuit
- Spiral cable with sensor sub-assembly (steering sensor)
|