| Skid Control ECU Communication Stop Mode |
Either condition is met:
- "Skid Control (ABS/VSC/TRAC)" is not displayed on the "CAN Bus Check" screen of the Techstream (Refer to PROBLEM SYMPTOMS TABLE [11/2015 - ]
)
- Communication system DTCs (DTCs that start with U) that are output correspond to "Skid Control ECU Communication Stop Mode" in "DTC Combination Table" (Refer to DIAGNOSIS SYSTEM [11/2015 - ]
)
|
- Brake booster with master cylinder assembly (skid control ECU) branch line or connector
- Power source circuit of brake booster with master cylinder assembly (skid control ECU)
- Brake booster with master cylinder assembly (skid control ECU) ground circuit
- Brake booster with master cylinder assembly (skid control ECU)
|