| Power Steering ECU Communication Stop Mode |
Either condition is met:
- "Power Steering (EPS)" is not displayed on the CAN Bus Check screen of the Techstream (Refer to PROBLEM SYMPTOMS TABLE [11/2015 - ]
)
- Communication system DTCs (DTCs that start with U) that correspond to "Power Steering ECU Communication Stop Mode" in "DTC Combination Table" are output (Refer to DIAGNOSIS SYSTEM [11/2015 - ]
)
|
- Power steering ECU assembly branch line or connector
- Power source circuit of power steering ECU assembly
- Power steering ECU assembly ground circuit
- Power steering ECU assembly
|