Open in One Side of CAN Branch Line [11/2015 - ]: Procedure

1. Based on the vehicle equipment and specifications, confirm the systems that use CAN communication (Refer to DIAGNOSIS SYSTEM [11/2015 - ] ).
2. Using the Techstream, select and perform the CAN bus check (Refer to DIAGNOSIS SYSTEM [11/2015 - ] ).
3. Observe the screen for approximately 2 minutes to check the ECUs and sensors that are not displayed on the screen and also those that repeatedly appear and disappear from the screen.
4. Check the applicable communication stop mode for the ECU or sensor that is not displayed on the screen.

NEXT 

REFER TO CORRESPONDING COMMUNICATION STOP MODE 

Refer to PROBLEM SYMPTOMS TABLE [11/2015 - ] )