| Combination Meter ECU Communication Stop Mode |
Either condition is met:
- "Combination Meter" is not displayed on the "CAN Bus Check" screen of the Techstream (Refer to PROBLEM SYMPTOMS TABLE [11/2015 - ]
)
- Communication system DTCs (DTCs that start with U) that are output correspond to "Combination Meter ECU Communication Stop Mode" in "DTC Combination Table" (Refer to DIAGNOSIS SYSTEM [11/2015 - ]
)
|
- Combination meter assembly main line or connector
- Power source circuit of combination meter assembly
- Combination meter assembly ground circuit
- Combination meter assembly
|