| Certification ECU Communication Stop Mode |
Either condition is met:
- "Certification (Smart)" is not displayed on the CAN Bus Check screen of the Techstream (Refer to PROBLEM SYMPTOMS TABLE [11/2015 - ]
).
- Communication system DTCs (DTCs that start with U) that correspond to "Certification ECU Communication Stop Mode" in "DTC Combination Table" are output (Refer to DIAGNOSIS SYSTEM [11/2015 - ]
).
|
- Smart key ECU assembly (Certification ECU) branch line or connector
- Power source circuit of smart key ECU assembly (certification ECU)
- Smart key ECU assembly (Certification ECU) ground circuit
- Smart key ECU assembly (Certification ECU)
|