Installation [06/2015 - ]: Procedure

1. Engage the claws to install a new stop light switch mounting adjuster.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Insert the stop light switch assembly until the threaded sleeve hits the pedal.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   NOTE:

   • When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.
   • Do not depress or support the brake pedal.
2. Turn the stop light switch assembly a quarter turn clockwise to install the stop light switch assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Turn

   Torque

   1.5 N*m (15 kgf*cm, 13 in.*lbf) or less

   NOTE:

   • When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.
   • Do not depress or support the brake pedal.
3. Check the protrusion of the plunger.

   Protrusion of Plunger

   Area	Measurement
   A	0.5 to 2.6 N*m (6 to 26 kgf*cm, 5 to 23 in.*lbf)

   If the protrusion is not as specified, recheck the switch installation and inspect brake pedal adjustment if necessary.

   NOTE:

   • When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.
   • Do not depress or support the brake pedal.
4. Connect the connector.
5. Check that the stop light does not come on when the brake pedal is not depressed.

Refer to PROCEDURE - Step 28 [06/2015 - 01/2018] , or refer to PROCEDURE - Step 28 [01/2018 - ]