LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2018 >> Highlander XLE, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 234 (Panoramic Moon Roof - Diagnostic Codes & Symptom Tests - (Hybrid)) >> Panoramic Moon Roof System >> Symptom Tests >> Panoramic Moon Roof System does not Operate [02/2014 - ] >> Caution / Notice / Hint

Caution / Notice / Hint

WARNING: This page is about a different variant/trim than selected.
NOTE:
  • The sliding roof auto operation function can be customized. Make sure that the function is set to ON.

    Refer to CUSTOMIZE PARAMETERS [02/2014 - ]

  • If the sliding roof ECU (sliding roof drive gear assembly) or roof sunshade ECU (sliding roof drive gear assembly) is removed and reinstalled or replaced, the sliding roof ECU (sliding roof drive gear assembly) or roof sunshade ECU (sliding roof drive gear assembly) must be initialized.

    Refer to INITIALIZATION [02/2014 - ]

  • The panoramic moon roof system uses the CAN and LIN communication systems. First, confirm that there are no malfunctions in the CAN and LIN communication systems. Refer to How to Proceed with Troubleshooting.

    Refer to HOW TO PROCEED WITH TROUBLESHOOTING [02/2014 - ]

  • If a sliding roof ECU (sliding roof drive gear assembly) DTC is output, first perform troubleshooting for the sliding roof ECU (sliding roof drive gear assembly) DTC.

    Refer to DTC CHECK / CLEAR [02/2014 - ]

scientia non olet · About LEMON Manuals