LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2018 >> Highlander XLE, FWD >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Control System (2GR-FKS) (Service Information) (Except Hybrid) >> Engine Coolant Temperature Sensor >> Removal [11/2016 - ] >> Procedure

Removal [11/2016 - ]: Procedure

  1. REMOVE V-BANK COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 25

  2. DRAIN ENGINE COOLANT 

    Refer to PROCEDURE - Step 1

  3. REMOVE ENGINE COOLANT TEMPERATURE SENSOR 
    1. Disconnect the engine coolant temperature sensor connector.
      GTY682748Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the clip and engine coolant temperature sensor from the water outlet.
      GTY659021Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:

      If the engine coolant temperature sensor has been struck or dropped, replace it.

scientia non olet · About LEMON Manuals