LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2018 >> Highlander XLE, FWD >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Control System (2GR-FKS) (Service Information) (Except Hybrid) >> Crankshaft Position Sensor >> Removal [11/2016 - ] >> Procedure

Removal [11/2016 - ]: Procedure

  1. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH (TWC: Front Catalyst) 

    Refer to REMOVAL [11/2016 - ]

  2. REMOVE CRANKSHAFT POSITION SENSOR PROTECTOR 
    1. Remove the nut and hose clamp from the crankshaft position sensor protector.
      GTY682744Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 3 bolts and crankshaft position sensor protector from the cylinder block sub-assembly and oil pan sub-assembly.
      GTY658050Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. REMOVE CRANKSHAFT POSITION SENSOR 
    1. Disconnect the crankshaft position sensor connector.
      GTY702779Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *A w/o Stop And Start System
      *B w/ Stop And Start System
    2. Remove the bolt and crankshaft position sensor from the cylinder block sub-assembly.
      NOTE:

      If the crankshaft position sensor has been struck or dropped, replace it.

scientia non olet · About LEMON Manuals