LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2018 >> Highlander XLE, FWD >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Control System (2GR-FKS) (Service Information) (Except Hybrid) >> Camshaft Position Sensor >> Removal [11/2016 - ] >> Procedure

Removal [11/2016 - ]: Procedure

  1. REMOVE INTAKE AIR SURGE TANK ASSEMBLY 

    Refer to REMOVAL [11/2016 - ]

  2. REMOVE VVT SENSOR (for Intake Side of Bank 1) 
    1. Disconnect the VVT sensor connector.
      GTY732857Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the bolt and VVT sensor from the cylinder head cover sub-assembly.
      NOTE:

      If the VVT sensor has been struck or dropped, replace it.

  3. REMOVE VVT SENSOR (for Exhaust Side of Bank 1) 
    1. Disconnect the VVT sensor connector.
      GTY695412Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the bolt and VVT sensor from the cylinder head cover sub-assembly.
      NOTE:

      If the VVT sensor has been struck or dropped, replace it.

  4. REMOVE VVT SENSOR (for Intake Side of Bank 2) 
    1. Disconnect the VVT sensor connector.
      GTY695419Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the bolt and VVT sensor from the cylinder head cover sub-assembly LH.
      NOTE:

      If the VVT sensor has been struck or dropped, replace it.

  5. REMOVE VVT SENSOR (for Exhaust Side of Bank 2) 
    1. Disconnect the VVT sensor connector.
      GTY732859Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the bolt and VVT sensor from the cylinder head cover sub-assembly LH.
      NOTE:

      If the VVT sensor has been struck or dropped, replace it.

scientia non olet · About LEMON Manuals