LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2018 >> Highlander XLE, FWD >> Repair and Diagnosis >> Engine Mechanical >> Starter >> Starting System [2GR-FKS] (W/ Stop And Start) - Service Information - (Except Hybrid) >> STARTER (w/ Stop And Start System) >> Installation [11/2016 - ] >> Procedure

Installation [11/2016 - ]: Procedure

  1. INSTALL STARTER ASSEMBLY 
    1. Type B:
      1. GTY706103Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        *a 26.5 mm (1.043 in.)
        *b 18 mm (0.709 in.)
        *c 50 mm (1.969 in.)

        Using an E8 "TORX" socket wrench, install the 2 stud bolts to the automatic transaxle assembly.

        Torque: 37 N*m (377 kgf*cm, 27 ft.*lbf) 

      2. Install the starter assembly with the 2 nuts.

        Torque: 37 N*m (377 kgf*cm, 27 ft.*lbf) 

    2. Type A:
      1. Install the starter assembly with the 2 bolts.

        Torque: 37 N*m (377 kgf*cm, 27 ft.*lbf) 

    3. Connect terminal 30 with the nut.

      Torque: 9.8 N*m (100 kgf*cm, 87 in.*lbf) 

    4. Close the terminal cap.
    5. Connect the starter assembly connector.
  2. INSTALL AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE 

    Refer to PROCEDURE - Step 62

  3. INSTALL INLET AIR CLEANER ASSEMBLY 

    Refer to PROCEDURE - Step 63

  4. INSTALL BATTERY 

    Refer to PROCEDURE - Step 64

  5. INSTALL V-BANK COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 91

  6. INSTALL COOL AIR INTAKE DUCT SEAL 

    Refer to PROCEDURE - Step 4

  7. INSTALL RADIATOR SIDE SEAL RH 

    Refer to PROCEDURE - Step 5

  8. INSTALL RADIATOR SIDE DEFLECTOR SEAL LH 

    Refer to PROCEDURE - Step 6

  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to INITIALIZATION [11/2016 - ]

scientia non olet · About LEMON Manuals