Removal [11/2016 - ]: Procedure

for UA80E: Refer to REMOVAL [11/2016 - ]

for UA80F: Refer to REMOVAL [11/2016 - ]

1. Using SST, hold the crankshaft pulley.
   • SST: 09213-70011 
     1. 09213-70020
   • SST: 09330-00021 

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Remove the 8 bolts, the rear drive plate spacer, the drive plate and ring gear sub-assembly and the No. 1 crankshaft position sensor plate.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Using a knife, cut through the lip of the rear engine oil seal.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Protective Tape
   *b	Cut Position

2. Using a screwdriver with its tip wrapped with protective tape, pry out the rear engine oil seal.
   NOTE:

   Be careful not to damage the crankshaft.