Installation [11/2016 - ]: Procedure

1. Apply adhesive to 2 or 3 threads of the engine oil pressure switch assembly.

   Adhesive

   Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Adhesive 1344
   *b	Oil Inlet Port

   NOTE:

   • Do not apply adhesive to the oil inlet port of the engine oil pressure switch assembly.
   • Install the engine oil pressure switch assembly within 3 minutes of applying adhesive.
2. Using a 24 mm deep socket wrench, install the engine oil pressure switch assembly.

   Torque: 15 N*m (153 kgf*cm, 11 ft.*lbf) 

   NOTE:

   Do not start the engine for at least 1 hour after installation.

3. Connect the engine oil pressure switch assembly connector.
4. Connect the wire harness protector.

See step  4

Refer to PROCEDURE - Step 1

See step  5

Refer to PROCEDURE - Step 98