Removal [11/2016 - ]: Procedure

See step  1

Refer to REMOVAL [11/2016 - ]

1. Set an engine lifter.
   WARNING:

   To prevent the engine assembly with automatic transaxle assembly from falling while servicing, do not remove SST.

   NOTE:

   Make sure that there is clearance between the automatic transaxle assembly and engine lifter.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Refer to PROCEDURE - Step 78

Refer to PROCEDURE - Step 32

Refer to PROCEDURE - Step 33

1. Remove the clip from the engine oil level sensor.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Remove the 2 nuts and engine oil level sensor from the oil pan sub-assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002