LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2018 >> Highlander XLE, FWD >> Repair and Diagnosis >> Engine Mechanical >> Lubrication System >> Engine Lubrication System (2GR-FKS) (Service Information) (Except Hybrid) >> Oil Pan And Oil Level Sensor >> Installation [11/2016 - ] >> Procedure

Installation [11/2016 - ]: Procedure

  1. SUPPORT AUTOMATIC TRANSAXLE ASSEMBLY 
    1. Set an engine lifter.
      NOTE:

      Make sure that there is clearance between the automatic transaxle assembly and engine lifter.

      GTY719187Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL ENGINE OIL LEVEL SENSOR 
    1. Install the engine oil level sensor to the oil pan sub-assembly with the 2 nuts.

      Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) 

    2. Install a new clip to the engine oil level sensor.
  3. INSTALL OIL STRAINER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 53

  4. INSTALL NO. 2 OIL PAN SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 54

  5. INSTALL BELT 

    Refer to PROCEDURE - Step 15

  6. INSTALL FRONT FRAME ASSEMBLY 

    Refer to INSTALLATION [11/2016 - ]

  7. ADD ENGINE OIL 

    See step  4

  8. INSPECT OIL LEAK 

    See step  5

scientia non olet · About LEMON Manuals