LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2018 >> Highlander XLE, FWD >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery / Charging System (2GR-FKS) (Service Information) (Except Hybrid) >> Generator >> Removal [11/2016 - ] >> Procedure

Removal [11/2016 - ]: Procedure

  1. PRECAUTION 
    NOTE:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Refer to PRECAUTION [11/2016 - ]

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to INITIALIZATION [11/2016 - ]

  3. REMOVE FAN SHROUD 

    Refer to REMOVAL [11/2016 - ]

  4. REMOVE FAN & GENERATOR V BELT 

    Refer to REMOVAL [11/2016 - ]

  5. REMOVE GENERATOR ASSEMBLY 
    1. Open the terminal cap.
      GTY713342Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the nut and disconnect the wire harness from terminal B.
    3. Disconnect the generator assembly connector.
    4. Disconnect the magnetic clutch connector.
    5. Disengage the 2 wire harness clamps.
    6. Type A:
      GTY713344Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Remove the 2 bolts and generator assembly bracket.
    7. Type B:
      1. Remove the bolt, nut and generator assembly bracket.
        GTY736805Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    8. Remove the 2 bolts and generator assembly.
      GTY306778Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    9. Remove the bolt and wire harness clamp bracket.
      GTY713339Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals