Installation [12/2013 - ]: Procedure

1. Apply MP grease to the lip of a new timing chain cover oil seal.
   NOTE:

   • Keep the lip free from foreign matter.
   • Do not allow MP grease to contact the dust seal.
2. Using SST and a hammer, tap in the timing chain cover oil seal until its surface is flush with the edge of the timing chain cover sub-assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   • SST: 09223-22010 
   NOTE:

   • Keep the lip free from foreign matter.
   • Do not tap in the timing chain cover oil seal at an angle.

1. Align the crankshaft pulley key with the key groove of the crankshaft pulley.
2. Using SST, hold the crankshaft pulley and install the crankshaft pulley bolt.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Hold
   *b	Turn

   • SST: 09213-54015 
   • SST: 09330-00021 

   Torque: 260 N*m (2651 kgf*cm, 192 ft.*lbf) 

   HINT: 

   SST (crankshaft pulley holding tool) fixing bolt part No.: 91551-80650 (2 pcs)

See step  1

See step  76, or refer to PROCEDURE - Step 76

See step  78, or refer to PROCEDURE - Step 78

See step  81, or refer to PROCEDURE - Step 81

Torque: 103 N*m (1050 kgf*cm, 76 ft.*lbf)