Typical Enabling Conditions
WARNING: This page is about a different variant/trim than selected.
ALL
| Monitor runs whenever the following DTCs are not stored | None |
P0335: CRANKSHAFT POSITION SENSOR RANGE CHECK/RATIONALITY
| All of the following conditions are met | - |
| Crankshaft position sensor | Signal input |
| Ignition switch | ON |
| Time after starter off to on | 3 seconds or more |
| Camshaft position sensor circuit fail | Not detected |
| Number of camshaft position sensor signal pulse | 6 times |
| Battery voltage | 7 V or higher |
| Minimum battery voltage while starter on | Less than 11 V |
P0335: CRANKSHAFT POSITION SENSOR VERIFY PULSE INPUT (CASE 1)
| All of the following conditions are met | - |
| Engine speed | 600 rpm or higher |
| Starter | Off |
| Time after starter on to off | 3 seconds or more |
P0335: CRANKSHAFT POSITION SENSOR VERIFY PULSE INPUT (CASE 2)
| Both of the following conditions are met | - |
| Starter | On |
| Minimum battery voltage while starter on | Less than 11 V |