LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2018 >> Highlander XLE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Automatic Transmission (U660F) - Service Information (1 Of 2)) >> Air Cooled Oil Cooler >> Removal [12/2013 - 11/2016] >> Procedure

Removal [12/2013 - 11/2016]: Procedure

WARNING: This page is about a different car, the 2016 Toyota Highlander, 2015 Toyota Highlander, and 2014 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE NO. 1 ENGINE UNDER COVER 

    Refer to PROCEDURE - Step 8

  2. SEPARATE FRONT FENDER LINER LH 

    Refer to PROCEDURE - Step 11

  3. REMOVE FRONT FENDER APRON SEAL LH 

    Refer to PROCEDURE - Step 13

  4. DRAIN AUTOMATIC TRANSAXLE FLUID 

    See step  4

  5. REMOVE TRANSMISSION OIL COOLER AIR DUCT 
    1. Remove the 2 bolts and transmission oil cooler air duct from the oil cooler assembly.
      GTY448182Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. REMOVE OIL COOLER ASSEMBLY 
    1. Slide the 2 clips and disconnect the No. 1 oil cooler outlet hose and No. 3 transmission oil cooler hose from the oil cooler assembly.
      GTY448181Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 2 nuts and oil cooler assembly from the oil cooler bracket.
      GTY448180Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. REMOVE OIL COOLER BRACKET 

    HINT: 

    Perform this procedure only when replacement of the oil cooler bracket is necessary.

    1. Remove the bolt, nut and oil cooler bracket from the body.
      GTY448175Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals