DTC U1103-87: Lost Communication with Stop and Start Control Module Missing Message [11/2016 - ]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Enter the following menus: System Select / Health Check.
5. Read the DTCs using the Techstream.

   Result	Proceed to
   DTC U1103-87 is output	A
   DTC U1103-87 and other DTCs are output	B

   HINT: 

   If any DTCs other than U1103-87 are output, troubleshoot those DTCs first.

Result: 

A 

GO TO CAN COMMUNICATION SYSTEM. 

Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [11/2016 - ] 

Result: 

B 

GO TO DTC CHART