DTC P0630-51: VIN Not Programmed [11/2016 - ]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Enter the following menus: Powertrain / Engine / Trouble Codes.
5. Read the DTCs.

   Powertrain > Engine > Trouble Codes 

   NOTE:

   If P0630-51 is output, the VIN must be written to the ECM using the Techstream. However, all DTCs are cleared automatically by the Techstream when the VIN is written. If DTCs other than P0630-51 are output, troubleshoot them first.

   Result	Proceed to
   DTC P0630-51 is output	A
   DTC P0630-51 and other DTCs are output	B

Result: 

B 

GO TO DTC CHART. Refer to  DIAGNOSTIC TROUBLE CODE CHART [11/2016 - 10/2017]  , or  DIAGNOSTIC TROUBLE CODE CHART [10/2017 - ]  . 

Result: 

A 

Go to next step 

1. Write the VIN.

   Refer to REGISTRATION [11/2016 - ]

Result: 

NEXT 

END