DTC P0115-2A: Engine Coolant Temperature Sensor 1 Signal Stuck in Range [11/2016 - ]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Enter the following menus: Powertrain / Engine / Trouble Codes.
5. Read the DTCs.

   Powertrain > Engine > Trouble Codes 

   Result	Proceed to
   DTC P0115-2A is output	A
   DTC P0115-2A and other DTCs are output	B

   HINT: 

   If any DTCs other than P0115-2A are output, troubleshoot those DTCs first.

Result: 

B 

GO TO DTC CHART. 

Refer to  DIAGNOSTIC TROUBLE CODE CHART [11/2016 - 10/2017] 

Refer to  DIAGNOSTIC TROUBLE CODE CHART [10/2017 - ] 

Result: 

A 

See step  2

1. Inspect the water inlet with thermostat sub-assembly (thermostat opening temperature).

   Refer to INSPECTION [11/2016 - ]

   HINT: 

   Perform "Inspection After Repair" after replacing the engine coolant temperature sensor.

   Refer to INITIALIZATION [11/2016 - ]

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE ENGINE COOLANT TEMPERATURE SENSOR. 

Refer to  REMOVAL [11/2016 - ] 

Result: 

NG 

REPLACE WATER INLET WITH THERMOSTAT SUB-ASSEMBLY. 

Refer to  REMOVAL [11/2016 - ]